L-Acoustics KIVA II

Console indication does not confirm the amplified output circuit.

1. Follow the intended controller input and output, mute and protection indications.
2. With the system safely muted, have the responsible technician compare approved cable and connector assignment. Do not increase gain to overcome an unidentified fault.
3. If the controller has input but reports mute/protection, the interruption is downstream of the console; do not compensate with gain. After an authorized correction, verify the intended circuit at controlled level. A persistent protection indication requires the responsible system technician or service.

Array curvature, aiming and signal paths influence coverage.

1. Compare the installed design and controller routes with the approved plan.
2. Document the listening locations and symptom before EQ changes. Mechanical changes require the exact rigging procedure and responsible personnel.
3. If the difference follows a routed zone, compare that zone’s processing; if it follows a physical listening area, request design/measurement review. Verify the same reference signal at the recorded locations after correction; do not change suspension as a listening experiment.

KIVA II depends on its supported controller and preset.

1. Read the actual model and library version rather than selecting by name similarity.
2. Check current amplification guidance for that controller and circuit. Do not invent cabinet-per-channel limits or bypass protection.
3. If model, preset or controller support cannot be confirmed, leave that circuit out of use until the responsible technician validates the exact documents. Verify the approved configuration before rehearsal; a similar name is not evidence of compatibility.