GLMedia — STRIDE: PTP, SWITCH AND INTERCOM DROPOUTS
BLANK TEMPLATE. No completed tests or GLMedia results are included.

Event / date / person responsible / plan and revision:
Antenna: ID / manufacturer / model / region / actual firmware:
Beltpack: ID / model / firmware / pool / configuration:
Green-GO Control: actual version / documentation source:

PATH BETWEEN ANTENNAS (repeat per segment)
Antenna A / port / cable / switch / uplink / switch / antenna B:
Switch: manufacturer / full model / operating system / version:
Manual: edition / section / link / pending condition:
PTPv2: TC or BC / profile / delay mode / assigned ports:
VLAN / IGMP snooping / PTP passage reviewed by / pending items:
PoE: standard / total budget / connected loads / status:
Previous configuration and values saved at:

DROPOUT OBSERVATION (repeat; do not enter example values)
Time / affected beltpacks / antennas / clients per antenna:
Stationary users or route / location / direction / occupancy:
Outgoing voice / reply / silence time / audible recovery:
Wired stations: test performed and result / untested:
Power / link / IP / lower LED / steady or flashing DECT logo:
Each antenna’s PTP: Domain / Priority2 / selected clock:
Control graph: screenshot / time / offset μs / duration / trend:
Manufacturer reference: green up to ±1 μs; yellow between 1 and 2 μs;
red above 2 μs. These are not measurements from this setup.

TEST AND SINGLE CHANGE
Question to check / initial condition / backup / agreed window:
Change / reason / who performs it / how to restore:
Conversation and route before / after / observed synchronization:
Result / cause still unconfirmed / pending / person responsible:

HANDOVER
Separate manufacturer requirements, proposed tests, and results observed on the actual equipment. Do not attribute the cause just because
conversation returned after a restart.