GLMedia — INTERCOM COVERAGE AND BASE CHANGES
BLANK TEMPLATE. These are not tests performed by GLMedia.

Event / date / person responsible / plan version:
Stations / groups / who hears whom / required reply:

EQUIPMENT (repeat per unit)
Identifier / manufacturer / full model / regional variant:
Role / associated headset or beltpack / actual version:
Manual / edition / page / firmware note / link:
Missing detail / support response:

NETWORK AND BASES
Cascade diagram / actual ports / cable / switch / fiber:
Switch: manufacturer / model / firmware / ports / PTPv2 and configuration:
Green-GO configuration / Stride Pool ID / PTP domain:
Hollyland Master/Remote / DHCP / previous state saved:
Supported combination / documented scope / unconfirmed:

SEGMENT TEST (repeat, out and back)
Time / sender / recipient / units / groups:
Start location / end location / direction / simultaneous people:
Initial and final base/antenna / connected clients / PTP status:
Power / cable / LED / state evidence:
Sent phrase / reply / audio both ways:
Dropout time / audible recovery time / measured duration:
Spontaneous recovery or after intervention:
Single change / state before / state after:
Result / untested segment / reason / pending owner:

OPERATIONS HANDOVER
Users sharing each zone / documented capacity:
Approved route / pending route / agreed alternative:
Configuration restored / conversation checked by:
Separate manufacturer instructions, proposed tests, and results observed on this setup.